Methods of Water Purification

Clean, pure water is one of life’s necessities. What people in remote areas, back country hikers and poor people have in common is dependence on untreated, limited source of water that has a large possibility of being contaminated and must need to be purified before it can be safely used.
Carbon Filtration: the best and easiest way to do this is by using homemade carbon filter. Carbon is an active element that binds to almost everything. At a microscopic level, charcoal is greatly pitted and rough, which enormously increases its authentic surface area. When water runs slowly over charcoal, impurities where glued to the charcoal surface. An improvised filter can be made out of strainer, funnel and ground-up charcoal. It is a simple yet effective technique.
Solar distillation: solar distillation is one of the methods used for water purification. This method can purify water in just one step, distillation. It is the process of distilling water using solar energy. In the simplest form, raw water is placed in air tight collector with a sloped covered material, and when the raw water is heated and evaporates, the water condenses on the collector covering and runs down where it can be collected by the use of a tray.
Reverse Osmosis filter: this is one of the methods of water filtration. It works by using by forcing a solution going through a membrane; the purified water that comes from the membrane will set aside and allows the pure solvent to pass through the other side. This process is the only one that deals with harmful bacteria and contaminants at the same time. This method is dependable but expensive and needs electricity for it to be able to work. As a result, this is the choice used for fixed position or by those which can afford to pull a small trailer with an electrical generator around but to those who can’t afford to have a generator or without access to electricity, there’s another option or method which you can use.
Microorganisms: the first step for water purification tag team is to eliminate and destroy microorganisms such as parasites and harmful bacteria. The most familiar way on how to get rid of microorganisms is by boiling. Just simply bring the water to its boiling point of 212 degrees Fahrenheit and as a result, it will kill and destroy harmful disease-causing harmful microorganisms such as bacteria, fungi, algae, Cryptosporidium parvum, amoeba cyst and giardia lamblia which are usually found in the water. Just a few minutes of boiling will do the job.
Other option is by using iodine tablets to destroy and eliminate unwanted bacteria in local water resources. Bleach is also popular in remote areas as it is utilized in killing germs and microorganisms in local water. Just eight drops of chlorine per gallon will make the water safe for drinking. These methods will allow approximately half an hour to do their job in killing microorganisms and as a disinfectant.